We were at Inks Lake SP this last weekend and was hoping to take advantage of their free wifi. My ever so wonderful HP card didn't do so well. I almost had to...
Jerry, My recommendation is to get a USB type device with a cable and then put the antenna in the window. You can move it around that way and also use an...
Jerry, One thing to keep in mind is that you not only need to be able to hear the access point you are trying to connect to but the access point must also be...
I forgot to mention, FAB-Corp also give an Amateur Radio discount. Just be sure to mention it to them when ordering. 73, Keith www.KB8SOE.com ... do so ... ...
There are a lot of ways to skin this cat. At the Plano Balloon Festival the church had WiFi but we could not access it from the roof where our antenna pointing...
That's exactly what I did for my 3 month RV trip to Alaska! I used a Linksys WRT54GL loaded with DD-WRT used in the bridge mode. I used one of the yellow...
If you don't want an HSMM project where you have to set up a waterproof, power-over-ethernet custom flashloaded Linksys router there are a couple of things you...
The seatlewireless web site lists a lot of hardware specs, including tx/rx for many many cards. I'm not sure how current it has been kept but it would be a...
I think I like Doug's solution best. A gain antenna on a mast allows me a bit more flexibility at the camp grounds so I don't need to restrict myself to a site...
Doug, When you get a chance let me know which one of those antennas it is from that web site that I need. I have no issues re-installing the board inside their...
Jerry Hi - can you outline the steps to use a second wireless router to make a repeater system? I live less than 3 miles from my work and have cable modem at...
The main thing is Line of Sight. WiFi does not go through trees. I used DD-WRT software in a Linksys or Buffalo WiFi Router. Check the DD-WRT website to get a...
Thank you I looked at the web page and it looks complicated...I will read the instruction page carefully over the next few days...I have 3 Linksys routers...
Actually when I think about it a little more all I need is a router and antenna for AP at my friends house since he also has cable modem so that should...
Kip, I like skinning Kitty Cats. They taste like chicken. Anyway... I got me another WRT54G Ver.2 and now I want to load the DD- (what ever it was) firmware on...
Hello Doug and the Group I'm an LMR tech at Kennedy Space Center in Florida and your fellow Ham. We have a church-based Ham group that responds to disasters to...
Check out John Beadles' (N5OOM) excellent website at: http://www.n5oom.org/hsmm/index.htm You can see the equipment I have built in the photos section under...
Randy, I have been asked to write the HSMM section in the new League publication VHF Digital Radio Handbook. If you don't mind, I would like to use some of...
Hello John, No problem. You can borrow my equipment and, given sufficient lead time, I can give you a description of each piece of gear. I also have...
There will be a TBM Communicator information table set up for NCTECH Hamfest this Saturday. I'll be on site for the ham-fest. Look for me there. There wil...
I hope that you will not do yourself a dis-service for following the advice. I know the candidate for vice-director and he can not come close to doing the job...
Coy Day and David Woolweaver were very strong supporters of the HSMM WG and still support the several good ideas that came from that effort. Walt/K5YFW...
We now have a notice that the D-STAR grant that Ed McGinley, W5ETM, applied for was approved. It is $99,000. I think he has shown a continuing ability to...
Come, Come, Tom! Let's not snipe the HSMM y-group for pet candidate puffery. I would humbly suggest you consider starting an ARRL Elections group for those ...
Randy, I joined this Yahoogroup in in 2004, on hearing presentations at club meetings and conventions about HSMM. I had some ideas of my own about the way a...