Hi Martin, I haven't had much luck myself with this problem, the elm chip and scantool will probably not be any use, (not on mine anyway). The best results...
... etc). ... data ... Hi Again. So there is no way of reading fault codes on this model at all?? What software did you use to connect to the ECU?? I can try...
... Hi Martin I would guess that flash codes can only be read via the security system, but I cant be really sure. There must be some way of reading fault codes...
... wrote: Hi Martin I think the last message went awol, so I'm resending. I dont think you will read flash codes unless you can get past security. There must...
Hello. For reading codes jou must connect a led tester bytween c3 and +. And connect a wire on c2,then ign on and connect c2 wire for 3-4 sec to -.(You get the...
Hi again Pugdud. Yes, I would very much like to try the software. I just got to make sure that it wont damage my ECU?? I dont know that much about software...
... I've got the bits together for you but there's quite a lot of it and I think it will junk up the groups board, can I e-mail it to you somehow? pugdud...
you can use "portmon" from sysinternals http://www.sysinternals.com/ntw2k/freeware/portmon.shtml running on laptop that send commands via com port Regards ... ...
So far as I know DS2 timing: 9600 bps +- 2.5%, 8E1, checksum XOR Interbyte time ECU 0.2ms < 20ms Interbyte time tester 0 ms < 20ms Interblock time > 25 ms...
Hello i have installed DABE on my laptop. But i get Run-time error-2147287010(8003001e) DeviceI/O error. I have registered it under dos with command regsrvr32...
Hello Thanks for your reply zapotec. I have tryed it and it looks fine I work also with advanced serial portmonitor from AGGsoft This program works a little...
Thanks for sk and Tim but I think the faults P1826 and P1827 are special from dealer because the code beguin with P1 (P1XXX) and the description is other, do...
Actually i'm using a DS2 interface realized with a maxim rs232 and a ttl 7407. You can find this interface in file section with ds2 program of gustavo garcia. ...
Hello Darqss I think you talk about alfa 8f.68 k 15 l 10 + 35 (from main relais pin 87) - 17 34 12 + 14 (out to different sensors/actuators) Myself work on...
Hi, I ´ve developed a code in VB6, that initialize a ecu. I use a dll so I can switch the port to 10400 bps. The 5bps to init I switch the port for 200ms...
Hi ! I'm interesting by your dll... which Dll do you use ? Thank you Mathieu ... From: gonzimann To: opendiag@yahoogroups.com Sent: Friday, November 05, 2004...
Does anyone use OBD to access an ECU outside of the car? I want to develop the hardware / software but not interfacing to my car's ECU directly. I'd like to...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
