So I'm working on a PIE script so that I can control Midnight Club 2 with the P5. I'm trying to get the analog accelleration to be controlled with the amount...
Sounds like you need an IF statement. If I understand it correctly, your mouse Y position would be controlled by the index finger. This value is from 0 to 63,...
An update to my situation: The connector samples that I requested from molex arrived. I no longer need the FFC connectors. However, I'm still missing the most...
Hi out There I need to convert the Signals from my Joystick (which seem to be 9-bit per Axis -> 0-511) to Midi-Signals with only 7-bits per Channel (0-127) ->...
There is a new yahoo group for people needing help with PIE... http://groups.yahoo.com/group/glovepie By the way, a new version of PIE is coming out in a...
Well, isn't this ironic. I had made a sample request to Meritec for a sample of FFC cable 2" long, and it just came today. It even fits the connectors on the...
I want to use Dev C++ rather than pay Micro$oft. I found only one message in this group about that... from 2004. Is there a more recent driver available?...
I am well aware of the LED positions being pre-programmed. I would probably have to write a completely new driver in PIE to calculate the center spot. However,...
Whoa, the new version of PIE is out, with OSC support! So now I can just use PIE to send OSC control information to Flosc and use it to control Flash......
After some waiting, my samples of Flat Flex Cable and the corresponding connectors finally came. The FFC cable fit into the connectors and the connector on the...
why don't you set it up (I don't know the way to do this, but I know it's possible) so that one set of switches triggers a certain percentage of the...
I had not intended to emulate a joystick at the same time using the P5 mouse mode. I had thought of using 50% and 100% bends as button signals, but there are...
I have been experimenting with resistance values that the P5 glove board bend sensors can read. From experiments, I have learned that the raw values from the...
I downloaded the newest version of GlovePIE with its support for multiple fake cursors, and had a flash of inspiration! Why not use a cursor to represent the X...
I noticed that the position of the glove jumped around, seemingly randomly, as well as jittering a lot. Perhaps LEDs going in/out of the field were responsible...
... trac/wiki/P5DataGlove ... Thanks by this Info, but your link no working. The correct URL is: http://control.ee.ethz.ch/~lawrence/public-project- ...
... trac/wiki/P5DataGlove ... Hi, thanks by your info, but your link no working. The correct URL is: http://control.ee.ethz.ch/~lawrence/public-project- ...
... I imagine this is the case. There must be a lot of distortion between what the sensors see and the drivers expect the LED positions to be. I am thinking...
... Just to be clear: I did not run your test script. (I'm traveling and didn't bring the glove along.) The jittery position was observed only with the...
Can somebody with cable, or something, please consider Zipping up all the files from the "Files" section of this group into one block structure, and mailing it...
... all ... that ... Hi Chris, Your position is well apprecaited. Once upon a time there was a yahoo group for putting Chevy engines into Porsches. Being a...
I want to second this... Yahoo has been known to kill off groups for the flimsiest of reasons, or no reason at all. The mere glimmer of impropriety can get...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
