You could also just capture audio for 20 minutes, and then feed it to
the PICPAC and see if you have a bad packet. No splitter needed in that
case.

Byon

On 8/8/2006 7:55 AM, hallmorg wrote:
> Thanks for a quick response.
>
> It varies in frequency, but it's happening every 10 minutes or less.
> This morning it was happening every couple of minutes. It just seems
> to be dependent on the amount of traffic. I'll try to buy/make a
> splitter to record the audio and at least provide you with something
> to debug with.
>
> Morgan
>
>
>
> --- In picpac@yahoogroups.com, Byon Garrabrant <byon@...> wrote:
>> I'm sure there is. How often does it happen. Perhaps you can try
>> capturing audio with a sound card at the same time. When it fails, you
>> will be able to replay the failure, and send it to me to study.
>>
>> Byon
>>
>> On 8/7/2006 9:49 PM, hallmorg wrote:
>>> Hi,
>>>
>>> I'm using a picpac to decode APRS packets using the Decode1 code from
>>> the Files section. It's doing a reasonably good job of grabbing
>>> packets, but it occasionally runs away on a scrambled decode. From
>>> the looks of the data, it is usually a weather packet. Unfortunately,
>>> I can't tell from whom.
>>>
>>> Is there something that can be done about this? The main problem
>>> seems to be that once it gets a bad packet, it seems to get stuck in
>>> an endless loop until I reset it.
>>>
>>> Any thoughts on this?
>>>
>>> What other information would help diagnose the problem?
>>>
>>> Thanks,
>>>
>>> Morgan
>>> ke6bfh
>>>
>>>
>>>
>>>
>>>
>>>
>>>
>>> Yahoo! Groups Links
>>>
>>>
>>>
>>>
>>>
>>>
>
>
>
>
>
>
>
> Yahoo! Groups Links
>
>
>
>
>
>