--- In pjrcmp3@yahoogroups.com, "waveguide28" <waveguide28@...> wrote:
>
> --- In pjrcmp3@yahoogroups.com, "bartartfart" <bartartfart@> wrote:
> >
> > i have 2 hard drives in caddies and both have the same problem.
at
> > player power on all goes ok and music starts playing then HDD
spins
> > down after "buffering" then when i try to go to next/previous
track
> or
> > directory the drive dosn't spin up the whole thing hangs then
resets
> > the player reboots an halts at "Waiting for hard drive" and
reboots
> > over and over. if i remove power from the hard drive for a couple
of
> > secs the player will load up ok and start playing again until
spin
> > down then the hole problem starts over again. i have set spin
down to
> > none to get over this but this means the drive is spinning
> > continuasly. current firmware version is 6.90 unmodded. normally
use
> > BMW BeBox ver 6.31 Help.
> >
> I have the same problem. Can You help?
> joe
>
Dear MP3 friend,

I do have the same problem, my board was working well until I blown
the
87C52. I bought a new from PJRC and now after booting it
says "waiting
for the hard drive" and "experimental dev release" and the date of
the
release.It prints 15 to 20 seconds of dots and then loads from the
hard
drive. Plays a music and when I trie to change file it prints a lot
of
dots and then boots again. I checked the power and everything that
could
be checked. Please if you have a solution I would like to have it
too.
Thank you all.

Luis