Most of the answers to these questions can be found at PJRC's website in the FAQ section. ... Basic information is a PJRC's website. There is no manual at this...
some thing is wrong, i connect the player into my custom case, connect to the power source an then , smoke come from the player. I realy dont' now what...
I have a total of 3 32 Meg Simm's available for sale they are in working order and have been tested i took them from a old computer that i was no longer useing...
... It sounds like it's either the CS4334 DAC or the amp for the headphone jack. Does it sound better if you use the RCA or the headphone connector? ...
... little update i found 2 more 32 meg and 2 16 meg simms havent tested but they did come from a working pc had no vedio card in it but post didn't give any...
I still have 1 32MB(8-chips on each side) ($15), 1 8MB(2 chips)($5) and 1 16MB(8 chips on one side)($10) simm. For me, you will need to add $5 for shipping....
Looks like this went to my inbox and to the group. Please, when you do that be sure to mention in the email that you also sent it to the group. That way I can...
Okay, today I got a chance to try out a bunch of things: 1) transformers on the signal wires: 50ohm:70ohm ratio, no appreciable reduction in whine (ie. no...
The shareware and paying software could be scared! Here's CD'n'Go in is last version 2.00.945. A freeware able to rip your cd in MP3 and OGG using the best...
on the player it is the black connector, the one with the round hole in and the pin in the middle. this type of plug / socket combination is common on devices...
I'm not sure if it's a brand name or what they are sold as, but I've seen these connectors listed as Adapta-plugs or something real close. They come in a ...
I recognize those. They are where the AC adapter plugs in right? Of course it is. I think the reason that they are called a DC jack is because usually they...
Paul or anyone, How difficult would it be to modify current design to change ST MP3 decoder for the ST mp3pro decoder with 24 bit DAC or something that ...
OGG support would be cool, too, but to answer your question... :) It looks like other chips support serial data in for sending the MP3 or WMA data, but you'd...
... The only chip mentioned that actually exists today is the SigmaTel. This chip is not offered in small quantities, and SigmaTel does not even offer a...
Plug refers to the end on the power adaptor, and "jack" refers to the mating part soldered to the circuit board. The plug is inserted into the jack, and the...
I have finally just got my built, put in a case and evrything work to include the usb that I added to it. I know I mentioned it was complete before but one of ...
I bought a used Rev C board, and have been messing around with it some. I finally got a formatted HD and SIMM, so I'm working on a case now. I've been...
The most spectacular Thai Blockbuster movie « Ong Bak » is now available in DVD. For an unbelievable price of 12 US$ (10.5 Euros) you will get the shipping...
(See my comments interspersed within the original quoted message)... ... Yes, or maybe not. :) Yes if you shut the player off, however... In my case, I use...
Don't mind if some of these things are fairly obvious and you've already tried them... Your adapter is probably okay, unless it's too "small" for whatever you...
After looking through the troubleshooting, I've been testing various voltages. The MAX810 chip seems to have a problem. I have a Rev C board, and if you look...
... Hold on. 4.7 volts is far too much. You should not see more than 3.3, since the max810 and all that other circuitry all runs on 3.3 volts. On rev C, the...
Paul- Thanks for the quick reply. In my previous post, I mentioned that I'm getting anywhere from 17-20v from the adapter. Could this be causing the higher...
... No, this is not your problem. It is normal to get about 18 volts from those 12 volt adaptors with no load (only connecting to your multimeter). Rev C can...
Robin, Paul. I received the player/LCD last Sat. Thanks. WOW,!!!! It plays and sounds great!!!!. I have installed a 16Mb 72 pin SIMM and used an IBM DTNA-22160...
I have used a Toshiba 10G (MK1017GAP) for over a year with out a problem. The DC jack is center positive and I use a power supply for some old Altec computer...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
