In case any one else is searching for this stuff, I was pleased with these I got my wire from http://www.meci.com/ 8 awg XLPE Hookup Wire. Color: White. Priced...
... I think this is probably the case for all small engines. There's been little effort put into small engines, other than the racing circuit. I remember an ...
Hi Colin, Well done, this is not my drawing so I just made the basic correction perhaps I should learn 2D thinking for this paper stuff. Chris's first drawing...
11152
Colin Dedman
cjd121@...
May 1, 2003 11:34 am
Gary write :- ... Hi Gary, Chris's original drawing "C" is "right" in the sense that it is self consistent, but of course I cannot say whether you have wired...
Hi Colin, if I take 2 coils and from left to right wire them + - + - and the north poles on these both point right, then take one and without disconnecting its...
Garry, Glad I could help. So let's move on and see what we can do to help you with your motor. -Al ... From: garry [mailto:garry@...] Sent: Wednesday,...
I took out my 36v CityBug yesterday and had a great ride. I had a suspension seatpost that you sold me last season. It wasn't so bad but I did try to avoid...
... taken to ... that's ... It sounds like Garry thinks winding the coils differently, but running the electricity the same will make for 2 different ...
... Don't mix up the left hand rule with the right hand rule. If he has got the coils wound backwards, it would explain all the confussion this post has ...
Colin et al., (that's you Lee :-) Given these four outcomes for alignment of the coils, applied current and generated fields, what will be the induced fields...
On my 36V Currie system, I used an automotive battery cut-off switch as my primary power switch. Even the low-end one is rated at 100A/12V continuous...
From: "Lee, Al" <al.lee@...> To: <power-assist@yahoogroups.com> Sent: Thursday, May 01, 2003 10:29 AM Subject: RE: [power-assist] E-biking in MA ... ...
... There has been a lot of work done on small engines and many do come with catalytic converters and other pollution controls. But this drives up cost and...
Six Technologies That Will Change the World God's Ink Jet Robots You Can Relate To The Plane That Does Hong Kong and Back in a Day All-Day Portable Power...
Hi Spurge, I think you are confusing the direction of the power with the direction of the poles, my system causes the poles to remain the same while forcing...
11166
(no author)
(no email address)
May 1, 2003 10:28 pm
... All absolutely correct. You start off with the coils wired in phase, and then flip one coil, and reverse the connections, so you end up with the coils back...
Hi David, My motor uses a pull field not a push sorry if I relayed that wrong somewhere. I do indeed contend that I have in phase power with out of phase...
... somewhere. ... and a VR motor uses both, so we already have an example that works and follows all the rules. I doubt anyone who builds VR motors uses the...
Hi Colin, The only way I can conceive that you are getting the same readings with a single coil as you do with 2 coils wound opposite each other in the...
... direction of the poles, my system causes the poles to remain the same while forcing the current both input and output to flow in opposite directions in the...
Hi Spurge, Im sorry, but direction of power over the same winding always controls the poles, if you change the wires you get opposite poles, this is what your...
11172
Colin
cjd121@...
May 2, 2003 12:26 am
Colin wrote :- You start off with the coils wired in phase, and then flip one coil, and reverse the connections, so you end up with the coils back where they...
Everyone, I'm a newbie, both to e-biking and the group. Bear with me if these questions have been raised before. It seems obvious to me that a one speed...
Hi Colin, Lets say im happy with your representation at (A+,B-) (C-,D+). Can we agree that this represents when powered from an external source such as a...
11180
Colin
cjd121@...
May 2, 2003 2:54 am
... That's fine. The coils are parallel connected, in phase. ... Correct. ... Correct again. ... That is all OK, so long as we both understand that your terms...
... Larry: I've been looking at that, too. I think it's Randy who has a multi-speed rear end for his bike. If I recall his posts, he uses a very high...
Colin wrote:- However, it is inappropriate to talk about 'induced current' when a battery is connected to the motor. There is still 'induced voltage' (back...
