Using the USB station, I'm unable to configure the XBee for analog transmission. I've been through ins and outs with the guys at maxstream and the only...
Hi Steve, I know no reason why. I know with the base firmware can be updated and configured. I have a friend who works with the API modes and analog a lot,...
Also, when I have it plugged into my computer, the only line that is green is the CTS when in the "terminal tab." Me and a person from tech support went...
Hi Steve, Asked my friend to try things out. From a prior Email, are you saying you can't do anything in command mode? What are you trying to accomplish...
All I was trying to do so far was to just set up the XBees for analog, but I can't even write any parameters to it. From there I was going to hook one up to...
Ah, well, that's totally different than what I read into the 1st Email. What platform are you using? Did the drivers install OK? Have you tried a different...
I have downloaded XCTU software and have been trying to use that to configure the XBees. I put the XBee on the USB board to program it with parameters for...
Hi Steve, I don't know what could be wrong, but apparently it's not doing what you need. If you'd like to ship it back, I'll reimburse you for the cost of the ...
Plotting multiple data sources on the same y-axis vs time is quite straight-forward if all the sources have the same units (degrees F, for example) and the...
Hi Phil., What I've done in the past is to use the !TEXT instruction to make a 2nd color-coded scale on the right, then just scaled the values appropriately to...
Actually, thinking about it, to get it off the grid, you can't use !TEXT (! is on grid only), @TEXT can be used so they survive a refresh/clear of the plot. ...
Hi Phil,(missed your earlier request for example, sorry) The general format for the instruction is: @TEXT X-coor, Y-coor, size, color,text now, with the...
Hi Martin, Easy one for you. How do you change the font size, colour on the X Y axis etc on a plot please. I have looked everywhere for help on this to no...
Hi Stuart, easy Q, but too short an answer. They cannot be adjusted. The are auto-sized based on the width of the plot area. If you need something special,...
Hi Martin, The original plot was minimised and I was trying to plot to a plot along the bottom of the page but after several hours have given up. I will...
Stuart, Place the plot on the screen, place (AINVAL0) in the update section, then, since it is a macro, you need to go to the oAnalog object area and add ...
Martin, Thanks for the speedy response. Macro sent to your .edu mail for your perusal. Stuart ... section, then, ... add ... plot1 ... On ... up. I ... ...
Hello Martin, Your example was very clear and it works as advertised. Many thanks for the assistance as well as authoring a very nice plotting program. phil...
Hello Martin, A suggestion for some future release of StampPlot: The current version has a provision for giving the left-hand y-axis a label. Can you also...
Hi all... What a great program! Much better and easier than National Instruments stuff or WinWedge! I do have a question though.. whats the easiest way to...
Hi Doug, Thanks, for serial data and strings and such, it's pretty quick... but it's no where as capable as labview! If you go to the Object Configuration...
Hi Martin.. I think I'm almost there.. but am having a little trouble I don't understand. It looks like the lower case "b" that I'm sending out to the control...
If it is showing up in the message window, it seems to be a problem because it's treating it as a non-value for some reason. Do you have a description of the...
Hi Martin.. The control I'm communicating to is a PIC16F877A with my own firmware. I'm pretty sure the data format is ok as I modified the firmware to...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
