... Under what circumstances did you receive the advice to halt the zones ? In general that is not required, although there are some corner cases where LU...
On Fri, 01 May 2009 08:57:59 -0500 ... I've read it somewhre on sunsolve. Can't remember when/where ;-) ... I upgraded from u6->u7 just now. It went very very...
On Fri, 01 May 2009 08:57:59 -0500 ... I've read it somewhre on sunsolve. Can't remember when/where ;-) ... I upgraded from u6->u7 just now. It went very very...
Has anyone ever seen this panic on boot? I suspect a bad CPU, the system (x4540, Solaris 10U6 ZFS boot) became progressively less responsive, failed to...
... You might just be seeing the effect of some bad memory here. The symptom can be similar, but I have found that memory fails more often than the CPU. Try...
... Thanks Mike. I have managed to boot the box into failsafe mode, so the 32 bit kernel boots. There do appear to be some strange errors (all entries missing...
... I had a similar issue when I upgraded to build 111. Solaris recognized that it had a bad setup for grub and prompted me with the right svcadm command to ...
Hi all, I tried to send this mail to solaris mailing list which i found on the web but I think that list is not being used anymore. Please see attached mail. ...
Bhasker C V
bhasker@...
May 5, 2009 4:29 pm
48920
Setting wireless with WPA required a lot of reading and research. I suggest that you do through several stages (from easiest to hardest): 1. Set it up with...
I am trying to set up BIND to support my network, rather than use host files everywhere. I have managed to get named working but my brain is old and tired and...
hello, I wanted to experiment a little bit with JMF http://java.sun.com/javase/technologies/desktop/media/jmf/ and I discovered that it is available for Linux,...
... If Larry Ellison where to try to comprehend JMF he would quickly find that it's an experience in tearing down his Woodside mansion and building a new one....
Hi, I have installed Solaris 10 10/08 on an Ultra 24 a few months back.I used ZFS root mirror. Today I ran zpool status and found:- host1{root}48: zpool status...
On Thu, May 7, 2009 at 5:41 PM, Richard Skelton ... The scrub should try to fix any correctable error it can. I just spent the last couple of weeks fighting...
Hi, Well the zpool scrub has cleared the error message but has increased the iostat errors. Will a live upgrade to Solaris 10 U7 fix this situation? ...
On Thu, May 7, 2009 at 6:13 PM, Richard Skelton ... I suspect that you have some "dubious" sectors on the disk. That's probably what it's hitting. Doubt Sun...
On Thu, May 7, 2009 at 6:16 PM, Richard Skelton ... The x4500 has a tool which appears to be using the SMART technology, called hdtool. I'm not sure if it can...
... Bob, I'm not an expert but TTL (Time To Live) is setup in the master nameserver of the domain and means the amount of time the result is cached by any...
... I have a raidz volume in one box where I had checksum errors from time to time. Replacing HDDs didn' work, the problem was still there. Eventually I've...
... I have not seen any checksum errors. Just soft errors on both drives via iostat. /var/adm/messages looks clean. Could it be a SATA controller problem? ...
... It could be cable as well. Check SMART details of the drive. BTW do smartmontools work with SATA drives under Solaris already? HDTune is your friend. If...
You can find JMF for Solaris x86 in /usr/jdk/packages/jmf on Nevada/ Solaris Express installs. Its not, apparently, packaged or available for Solaris x86...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
