Yes I do, how many do you need? Mike. ________________________________ From: Eric Legnini <eric.legnini@...> To: sony-mxp-3k@yahoogroups.com Sent: Monday,...
Hello Eric, I will need your full address to figure out shipping costs. Mike. ________________________________ From: Eric Legnini <eric.legnini@...> To:...
Hey Jeff, I have 6 semi para's, and 4 fully para's. $90.00 for the semi, and $80.00 for the fully para's. Let me know what you need they're starting to go...
Yes ! Here is my address: Eric Legnini 86 , Rue du petit Château 94220 Charenton le Pont France Let me know Thankx eric ... Yes ! Here is my address: Eric ...
Is there some particular reason you guys are spamming the whole group with the details of your transactions? _____ From: sony-mxp-3k@yahoogroups.com...
I Will Do it this week-end ! Thanks ! I will @ when it's done ! Cheers ! Eric ... I Will Do it this week-end ! Thanks ! I will @ when it's done ! Cheers ! Eric...
I just recently moved and I am having problems with my console. The Sony was working fine until I moved it to a new location. I moved into a new house and was...
Pull the belly pans off and make sure all the header connectors between all the motherboards are well-seated. Pull all the modules out, clean the edge...
Thanks Jeff, I will do so and see if that solves all/most of the problems. Thanks, Dave To: sony-mxp-3k@yahoogroups.com From: jchestek@... Date: Sun,...
I agree with Jeff but also make sure all the patchbay ribbon cables are latched into place. All your goes ins and outs are on the belly pan side of the...
Hi Dave, I'll agree with Tom about the ribbon cables. My church bought a 3036 and after shipping it didn't work. Many symptoms same as yours which had me ...
Hello Everyone, I have recently purchased a 3036 for our studio. For the most part I have to console up and running smoothly, although I am having an issue...
Hi Jeff, I know very little, but, you can run a 3036 without the automation enabled/turned on. If the problem faders act the same way without auto turned on,...
First thing. You do have the automation power supply and the console power supply connected to the same grounded outlet, with the ground pins intact? Once...
Thank you both for your quick replies. I do have both power supplies on the same grounded outlet. I have tried the MASTER MODE 5 9 to view the addressing....
OK, try swapping known good modules into those two slots. That'll isolate the problems to either the module or the frame (wiring harnesses/motherboards). It...
O.K., hears the upate, so far the problems ended up being in the patchbay. The little nub things on the patch contacts had debris in between them. I just...
Hi Jeff, I have swapped known good fader modules into those slots with no result. I do have the fader extender module but do not have a scope (or remember how...
For the sake of completeness, try swapping I/O modules too. If the problem follows the module, then find the VCA module on the channel board, and try swapping...
Thanks for the info. I am going to try swapping around I/O modules tomorrow when im at the studio. From the fader modules I have removed so far there I have...
Offhand, I can't tell you how to identify the different fader boards, I haven't run across the older AFB, and I'm not going to be near my manuals until...
Sorry. IT says AFBII on the printed Circuit board. Tom graefe@... ... From: Tom Graefe To: sony-mxp-3k@yahoogroups.com Sent: Thursday, May 21, 2009 3:56...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
