Bob,

is this the long awaited fix for my issue with the camera not starting properly
across machine reboots?

Thanks,
-esy

--- In starfish_camera@yahoogroups.com, Bob Piatek <bobtek@...> wrote:
>
> Dale,
>
> All you should need to do is to run the installer. The only thing it
> does is update the camera firmware file that gets loaded to the camera
> when you first power up the camera.
>
> The camera plug-ins for MaxImDL and CCDSoft have not changed. You
> should get the latest version of PHDGuiding though since that is what
> I tested with.
>
> Thanks to Craig Stark and Kenneth Hess for helping track this problem
> down.
>
> Regards,
>
> Bob Piatek
>
> fishcamp engineering
> 105 W. Clark Ave.
> Orcutt, CA 93455
>
> http://www.fishcamp.com
> TEL: 805-937-6365
> FAX: 805-937-6252
>
>
>
>
> On May 29, 2009, at 7:47 PM, Dale Ireland wrote:
>
> >
> >
> > Hello
> > I have the previous release installed. I have MaximDL V5. Will this
> > work
> > with v5?
> > I suffer frequent loss of communication with the camera requiring
> > reboot or
> > at least disconect-reconect of the camera esp when tying to STOP
> > guiding in
> > PHDGuide .
> > Do I need to run the whole install routine again with this update or
> > just
> > put the new MaxImDL dll in its directory? Are the base files
> > different than
> > before or just the MaxImDL plug-in?
> > Does the setup file do everything or must I manually install all the
> > plugins?
> > Dale
> >
> >
>