True!
the only thing missing is lathe :-(.
Victor
----- Original Message -----
From: Tracy Presnell
To: turbocnc@yahoogroups.com
Sent: Wednesday, November 12, 2008 09:14 PM
Subject: Re: [turbocnc] Re: Choppy running steppers


I have to agree, Zeus is pretty much fantastic and as glitch free as
anything I've used.

Tracy

Rick Reyes wrote:
> Hey Wallace you running Zeus? How you like it? I got into it after having
much trouble with Turbo. Runs much better and alot faster to setup I have found.
>
>
>
> ________________________________
> From: Wallace Weideman <marshland.eng@...>
> To: turbocnc@yahoogroups.com
> Sent: Wednesday, November 12, 2008 1:34:34 AM
> Subject: [turbocnc] Re: Choppy running steppers
>
>
> I have had the same problems. Seems there is a bit stream hickup. Try
> Zeus software and see if it goes away. The glitch was enough to fault
> my servo drives. Are you running metric ?
>
> Cheers Wallace
>
>




[Non-text portions of this message have been removed]