I believe it requires 3 Identical screws if your going to do 3D stuff.
Victor
----- Original Message -----
From: Roland Jollivet
To: turbocnc@yahoogroups.com
Sent: Thursday, November 13, 2008 02:23 AM
Subject: Re: [turbocnc] Re: Choppy running steppers


Hi

I've just looked at the Zeus page again after about two years. It's very
vague.
Does the software still require three identical motors, or can the axis
config be set independantly?
Does it have CV?

I know it's the wrong forum, but there's not much traffic here.

Regards
Roland

2008/11/13 Tracy Presnell <tpres@...>

> Yeah, Jeff says he's working on it. I just don't think he's working real
>
> fast, though.
>
> It can still be used for a lathe just with limitations.
>
> Tracy
>
> Victor Faria wrote:
> > True!
> > the only thing missing is lathe :-(.
> > Victor
>
> > ----- Original Message -----
> > From: Tracy Presnell
> > To: turbocnc@yahoogroups.com <turbocnc%40yahoogroups.com>
> > Sent: Wednesday, November 12, 2008 09:14 PM
> > Subject: Re: [turbocnc] Re: Choppy running steppers
> >
> >
> > I have to agree, Zeus is pretty much fantastic and as glitch free as
> > anything I've used.
> >
> > Tracy
> >
> > Rick Reyes wrote:
> > > Hey Wallace you running Zeus? How you like it? I got into it after
> having much trouble with Turbo. Runs much better and alot faster to setup I
> have found.
> > >
> > >
> > >
> > > ________________________________
> > > From: Wallace Weideman
<marshland.eng@...<marshland.eng%40xtra.co.nz>
> >
> > > To: turbocnc@yahoogroups.com <turbocnc%40yahoogroups.com>
> > > Sent: Wednesday, November 12, 2008 1:34:34 AM
> > > Subject: [turbocnc] Re: Choppy running steppers
> > >
> > >
> > > I have had the same problems. Seems there is a bit stream hickup. Try
> > > Zeus software and see if it goes away. The glitch was enough to fault
> > > my servo drives. Are you running metric ?
> > >
> > > Cheers Wallace
> >
> >
>
>

[Non-text portions of this message have been removed]





[Non-text portions of this message have been removed]