Jan,

Weird stuff is mainly a reference to the Tool Table. It probably works but
I have never figured it out.
Rough edges are when I try to feed it 4 decimal places and it chokes on a
Divide By Zero Error (= dead computer). I have no reason for that many
decimal places, bad habit, other software copes just fine. I just have to
learn to think about reality and only use 2 places (which is still over
kill in mm on my mills).

My main mill still runs TCNC

jeffD

*********** REPLY SEPARATOR ***********

On 6/30/2009 at 10:41 PM rlwoodjr11 wrote:

>I do like the interface...I hope it does not change too much. What "rough
>edges and weird stuff" does turbocnc do?
>
>
>--- In turbocnc@yahoogroups.com, "Jeff Demand" <jdemand@...> wrote:
>>
>> Jan,
>>
>> No comments about TurboCnc5, I tend to run mills.
>>
>> As to 4.01 be careful what you wish for. 4 years and it has worked just
>> fine for me, granted there some rough edges and weird stuff. Major
>software
>> updates tend to scare me and usually require a re-learning experience.
>And
>> NO program is ever finalised for all users.
>>
>> jeffD
>>
>> *********** REPLY SEPARATOR ***********
>>
>> On 6/27/2009 at 7:19 PM on6jg wrote:
>>
>> >I'm very dissapointed to notice that even after three months now we
have
>> >not received any news nor any updates from AST about the new WIN
Version
>> >of Turbocnc5. The latest update was on March 25th 2009.
>> >
>> >Even worse is the fact that after 4 years, 2005 was the release year of
>> >Turbocnc V 4.01, we are still left in the cold on updates or on a
>> >finalised program.
>> >


-
Demand Designs
Analog/Digital Modelling & Goldsmithing

http://www.gmavt.net/~jdemand
jdemand@...
-