All, I need some help here. I have a simple VB app that checks the DI 1 (in fact i have a 12V between Dig 0 and Dig 1) and if I start the app with nothing...
-999 is generated when 194 stops responding to commands from PC. 12V between Dig 0 and Dig 1? Isn't it too high for 194? The transient may have reset the micro...
I'm doing some research for a professor, working with equipment that he purchased and have next to no programming experience. The DI-148U-SP is being used to...
I'm doing some research for a professor, working with equipment that he purchased and have next to no programming experience. The DI-148U-SP is being used to...
Any suggestions on the taking just 240 samples in a second and stop taking measurements, and then store those 240 values in an array for those channels? The...
UltimaSerial.EventLevel = 480 Take a closer look at the VB samples that comes with the installation Also see NewEvent, EventLevel, GetData & Stop ... an user ...
Download 710 Record Scheduler <http://www.ultimaserial.com/uscheduler.EXE> Here it is again: 1) Support Stand alone 710, 715B, 718B, 718bx 2) Support both USB...
What are the port settings for the DI 194 and what are the trigger commands? I was trying to use http://www.dataq.com/support/techinfo/dataform.htm Null, C, 0 ...
I did an upgrade from microsoft that required me to re-install ultimaserial. So I went with the latest on the web. Now my application captures "Cells(3, 5) =...
Hello everyone. I'm currently using UltimaSerial 3 in VB.Net with my DI-148U, and am running into a bit of trouble. Now, I'm not a programmer by any stretch...
148U can run much faster than 240 s/s NewData event is fired when there at least <EventLevel> amount of data, you may be getting 50-60 events, but each event...
My apologies for such a delay in replying, but I suffered a recent hard disk crash and have had to spend the last week recovering. Anyways... This is becoming...
1) To control digital output, please download digital_dac_output.zip in the file section of this group 2) To read just a single data point, please refer to the...
Yes, that is pretty much what I have been doing. The main issue is finding the properly long "some delay..." that gives the device enough time to get a new...
The USB device driver can't send out digital output command as fast as you wish. You may consider using a pulse generator if you need to send out pulse rate...
The DI-158 affords two 12 bit analog out signals. Maximum voltage out is 1.25 Volts (I think). What I am trying to do using VB 6 preferred is generate a low...
Many thanks. I missed it when I looked. That is all I need to get me started. Thanks again. Ron ... out ... preferred is ... Frequencies ... signals ... ...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
