I'm doing some research for a professor, working with equipment that he purchased and have next to no programming experience. The DI-148U-SP is being used to...
Any suggestions on the taking just 240 samples in a second and stop taking measurements, and then store those 240 values in an array for those channels? The...
UltimaSerial.EventLevel = 480 Take a closer look at the VB samples that comes with the installation Also see NewEvent, EventLevel, GetData & Stop ... an user ...
Download 710 Record Scheduler <http://www.ultimaserial.com/uscheduler.EXE> Here it is again: 1) Support Stand alone 710, 715B, 718B, 718bx 2) Support both USB...
What are the port settings for the DI 194 and what are the trigger commands? I was trying to use http://www.dataq.com/support/techinfo/dataform.htm Null, C, 0 ...
I did an upgrade from microsoft that required me to re-install ultimaserial. So I went with the latest on the web. Now my application captures "Cells(3, 5) =...
Hello everyone. I'm currently using UltimaSerial 3 in VB.Net with my DI-148U, and am running into a bit of trouble. Now, I'm not a programmer by any stretch...
148U can run much faster than 240 s/s NewData event is fired when there at least <EventLevel> amount of data, you may be getting 50-60 events, but each event...
My apologies for such a delay in replying, but I suffered a recent hard disk crash and have had to spend the last week recovering. Anyways... This is becoming...
1) To control digital output, please download digital_dac_output.zip in the file section of this group 2) To read just a single data point, please refer to the...
Yes, that is pretty much what I have been doing. The main issue is finding the properly long "some delay..." that gives the device enough time to get a new...
The USB device driver can't send out digital output command as fast as you wish. You may consider using a pulse generator if you need to send out pulse rate...
The DI-158 affords two 12 bit analog out signals. Maximum voltage out is 1.25 Volts (I think). What I am trying to do using VB 6 preferred is generate a low...
Many thanks. I missed it when I looked. That is all I need to get me started. Thanks again. Ron ... out ... preferred is ... Frequencies ... signals ... ...
The issue/problem is about being able to dynamically set the DATAQ 158 device channel gains. I need to change the device gains during the operating phase. It...
... From: ultimaserial <no_reply@yahoogroups.com> To: ultimaserial_group@yahoogroups.com Sent: Monday, May 19, 2008 4:16:40 AM Subject: [ultimaserial_group]...
Sorry, but Dataq is responsible for the hardware capability of DI-158 ... 158 ... UltimaSerial" implied that the programable Gain table would set DI-158 ...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
