1) To control digital output, please download digital_dac_output.zip in the file section of this group 2) To read just a single data point, please refer to the...
Yes, that is pretty much what I have been doing. The main issue is finding the properly long "some delay..." that gives the device enough time to get a new...
The USB device driver can't send out digital output command as fast as you wish. You may consider using a pulse generator if you need to send out pulse rate...
The DI-158 affords two 12 bit analog out signals. Maximum voltage out is 1.25 Volts (I think). What I am trying to do using VB 6 preferred is generate a low...
Many thanks. I missed it when I looked. That is all I need to get me started. Thanks again. Ron ... out ... preferred is ... Frequencies ... signals ... ...
The issue/problem is about being able to dynamically set the DATAQ 158 device channel gains. I need to change the device gains during the operating phase. It...
... From: ultimaserial <no_reply@yahoogroups.com> To: ultimaserial_group@yahoogroups.com Sent: Monday, May 19, 2008 4:16:40 AM Subject: [ultimaserial_group]...
Sorry, but Dataq is responsible for the hardware capability of DI-158 ... 158 ... UltimaSerial" implied that the programable Gain table would set DI-158 ...
I'm just getting started with the UltimaSerial activeX control. I have a DI 148U and I'm programming in VB5 to record data from a new detector I have built....
Hi Dave, ... UltimaSerial Software. I don't know that I agree with your statement, yet. I downloaded the UltimaSerial software so I could program my DATAQ...
Some amateur seismologists who uses Windaq to collect earthquake data sync the clocks by checking the internet clock and embed the clock as event markers to...
... clocks on ... I'm new to writing programs for analyzing data, although I'm sure I could keep the clocks in sync. I'm more concerned with how easy (or...
1. I hate the Yahoo system. Too many distractions, too many pop-up glaring ads for useless products. However this is the only media currently vailable to...
I was able to run the old version AnalogWaveform.xls on my laptop with a DI-194RS connected. I just purchased a DI-148U to get the USB version and installed...
This is a common problem when upgrading ActiveX for VBA program, please refer to http://ultimaserial.com/exd.html That's why I personally prefer this approach ...
I am using Labview8.5 and when I run the program it gets stuck at the "Varient to Data" vi. Then I tried to redo the sample program but its still the same. Can...
http://ultimaserial.com/wdspectrum.html From Windaq, Highlight/Select an active channel and start a Meter for it Highlight/Select an inactive channel and start...
... To bring up meters for all channels at once using an inactive channel: Type in 1=0 in Windaq, and the first display channel will disappear Highlight/select...
