Hello I would like to learn how can I use when one of the digital channel is input, the other one is output. I searched in ultimaserial web site and I found...
See http://www.ultimaserial.com/standard.html#SetDIODir Each bit in the direction register controls the direction of corresponding digital I/O bits For...
Hallo, there are 3 digital i/o in this system. Can I use one as digital output and if so, how do I set it up in a VB6 program? Thanks in advance Olof...
Okay, I misunderstood the specification from dataq (say´s two digital inputs and one output, however only to be used intenally??). Would it be possible to use...
Update on Windaq add-on FFT II & Spectrogram II * For FFT size of 1024, all 32 channels can be enabled in Windaq * For FFT size of 2048, up to 29 channels can...
Does anyone have developed a Labview VI for the Agilent 4294A? I am having issues to display the data and save it (if I do it too fast it locks up the...
i am using a 5-turn 500 ohm pot as a position sensor the pot has a linear taper - confirmed with ohm-meter whether i use my own code or your sample code, the...
Once a while, you may end up damaging the file system on the SD used by DI-71x stand alone data logger. For example, you push and hold the action button for...
I heard that the USB drivers for DI-148/158 will not loaded automatically, and you can manually load them, but I think after that, the software should work...
Finally, I got my first peek at Windows 7, and here is what I found Since DATAQ' USB drivers are not signed, DI-148/158/710/718 will not prompt the user to...
"Because DI-148/158/710/718 uses FTDI's USB controllers, you may remove the jumper near the USB connector and turn DI-148/158/710/718 back to a generic...
After error message "Too many channels are enabled in Windaq so that it doesn't have enough memory to provide the data frame needed for the analysis." is...
Hi all, I have no experience in programming with any language. I'm trying to start with MS Visual Basic 2008 Express to control a DataQ DI-158U. I found the...
Dear all, Greetings to all !! and new to the group and would like to clarify my doubts as under. I am plotting the volts using the xchart, but then there are...
XChart is optimized for plotting only. The legend option of the chart identifies the color of each traces. Since grids are already in the chart, you can easily...
If this is still an active question I would ask if any software is being written and in what language? The recording of battery voltage, battery current and...
Hi All, Â I have dataq 194 rs DAQ borard and have recieved a WINDAQ pro software free.I am developing a DAQ software in matlab using Ultimaserial.Do I require...
1) Windaq pro is not for 194RS, so what you have is the free Windaq lite. 2) Ultimaserial and DATAQ are two different entities. 3) For more info regarding...
We are planning on using a DI-148U on our Cub Scout Pack's Pinewood Derby track. Does the pack qualify for a free license? I am also looking at using ActiveX...
... Usually not, but if your budget is limited, we will be glad to provide it for free. ... 148's sample rate is a lot higher than 194, so you should be able...
