The connector will be placed on the bottom of the board, but I need to flip the
pin numbers along with the trace in the board layout. Pin 1 must be in pin 2's
position, pin3 must be in pin 4's position, etc. The connector is not polorized
so pin 1 is pin 1 no matter what side of the board the connector is on due to
the lands running to each pin remaining the same. I guess I'll have to redesign
the part.
Thank Will

--- In winqcad_group@yahoogroups.com, Will Wasson <will.wasson@...> wrote:
>
> Do you mean you want to place it on the bottom of the board?
> If it's a through hole component then that would do the trick.
>
> --- On Thu, 3/12/09, cpatnoi <cpatnoi@...> wrote:
>
> From: cpatnoi <cpatnoi@...>
> Subject: [winqcad_group] Flip a part in PcbEdit
> To: winqcad_group@yahoogroups.com
> Date: Thursday, March 12, 2009, 5:04 AM
>
>
>
>
>
>
>
>
>
>
>
>
> I'm using a connector, CON_HDR::2X8A. Is there any way to flip
the part in PcbEdit? I can flip it in SchEdit by pressing the "X" key but I
can't flip it in PcbEdit. I can rotate the part but I can't flip the part to
get pin 1 in pin 2's position.
>
>
>
> Thanks,
>
>
>
> Charles Patnoi
>