ok the station name is ws-2310 twc, and i tested the reed switch and it works
fine... and also i replaced the wire so its good... but still nothing. i still
doesnt work. could it be the hydro/thermal sensor being messed up?

--- In wuhu_software_group@yahoogroups.com, "H. Smith" <wuhu_software@...>
wrote:
>
>  
> Check the reed switch with a continuity tester. It should close when you pass
a magent past it.
>
>
> --- On Wed, 7/8/09, mitchell <mtm81989@...> wrote:
>
>
> From: mitchell <mtm81989@...>
> Subject: [wuhu_software_group] rain gauge problems
> To: wuhu_software_group@yahoogroups.com
> Date: Wednesday, July 8, 2009, 9:58 PM
>
>
>
>
>
>
>
>
> ok, so today my rain gauge quit working. so i brought it in and looked inside.
everything was working good looked like, then i took the little sensor out of
the gauge. i looked to see if it was broke. then after i had it out the wire
broke from the sauder, then the other wire did too. so i desided to change the
wires because i thought there was probably a short in the wire somewhere. so i
did and still the rain gauge doesnt work. do anyone have a clue wat it could be?
>