Possible. Are you checking the changes to the rain total at the console or
within WUHU? If within WUHU make sure that "disable all rainfall reporting" and
"disable rainfall sensor" options are not checked.

I guess what I would to is use the meter at the end of the RJ-11 that connects
to the remote thermo. If that checks out ok, pop the case on the remote thermo,
trace the leads that go from the rain sensor's RJ11 port to where ever they are
routed on the printed circuit board. If the signal makes it all the way to the
chip it is connected to, then I would guess it is a bad sensor at that point.



--- In wuhu_software_group@yahoogroups.com, "mitchell" <mtm81989@...> wrote:
>
> ok the station name is ws-2310 twc, and i tested the reed switch and it works
fine... and also i replaced the wire so its good... but still nothing. i still
doesnt work. could it be the hydro/thermal sensor being messed up?
>
> --- In wuhu_software_group@yahoogroups.com, "H. Smith" <wuhu_software@> wrote:
> >
> >  
> > Check the reed switch with a continuity tester. It should close when you
pass a magent past it.
> >
> >
> > --- On Wed, 7/8/09, mitchell <mtm81989@> wrote:
> >
> >
> > From: mitchell <mtm81989@>
> > Subject: [wuhu_software_group] rain gauge problems
> > To: wuhu_software_group@yahoogroups.com
> > Date: Wednesday, July 8, 2009, 9:58 PM
> >
> >
> >
> >
> >
> >
> >
> >
> > ok, so today my rain gauge quit working. so i brought it in and looked
inside. everything was working good looked like, then i took the little sensor
out of the gauge. i looked to see if it was broke. then after i had it out the
wire broke from the sauder, then the other wire did too. so i desided to change
the wires because i thought there was probably a short in the wire somewhere. so
i did and still the rain gauge doesnt work. do anyone have a clue wat it could
be?
> >
>