Too bad about it, it had a lot of potential. Does Mach3 have too
width compensation? How much. Does anyone elso recommend anything
else? What have most of the users gone to?

Thanks

Larry

--- In yeagerautomation@yahoogroups.com, "Bob Muse" <mtebob1@...>
wrote:
>
> It's been that way for a while now. Doug surfaced about a year ago
with plans to write some new cnc software. Just about everyone who
replied to him said that he has been out of the picture too long and
to give up the idea-he would never be able to catch up with some of
the current guys. I was using cncpro on an almost daily basis up
until about 3 months ago. Built a new control for my flatbed mill
and installed mach3-wow what a difference! Mach3 is lightyears ahead.
>
> ----- Original Message -----
> From: dominickbox
> To: yeagerautomation@yahoogroups.com
> Sent: Sunday, December 31, 2006 11:18 AM
> Subject: [yeagerautomation] What happened to Yeager Automation.?
>
>
>
> Anyone know what happened to the Yeager Automation website? Also,
> anyone know what happened to this forum. it seems to have been
overrun
> with spam messages
>