Good day, I am about to upgrade the pc that I use to run my machine and I am having trouble moving my cncpro file to my new machine. I have copied and pasted...
John, I'm not sure what it is you mean "copied and pasted the file/folder". Are you trying to move the entire program to a new machine/disc? If so, that...
I am trying to setup and run dos/cncpro with a pc that has Windows XP installed. I have made a reboot disc with dos and can get the A drive only when starting...
Dos can not read the Windows XP filesystem NTFS and that is why you can't access drive C. I think you will have to use something like PTS-Dos or was it PT-2000...
Hi Asi; The Machinery's Handbook (Industrial Press) has a good explanation of RS274. You might also do some browsing through the files sections on the...
hi doug thanks for replying me (you the only one) i use solidcam + bently jmodeler (in israel) & i have turbo cnc & Yeager Automation software the problem is...
Asi; Unfortunately, the EIA standard defines the common G-codes but not the syntax used for those codes. CNCpro uses a syntax that is similar to Fanuc, but...
In a message dated 12/8/2003 7:31:06 AM Mountain Standard Time, yeagerautomation@yahoogroups.com writes: I would like to wire home limit switches. Is there a...
Yes, you can Fortino ... From: gv71 To: yeagerautomation@yahoogroups.com Sent: Tuesday, December 09, 2003 5:02 AM Subject: [yeagerautomation] gecko g320 drive ...
Im having setting up the tool table in cncpro. It seems that the program will not let me enter a negative value for a tool. It seems like the master tool...
It is a bug - or a feature - depending on your point of view. The problem has been discussed before so I guess it's a feature. I use my center drill as T0 and...
CNC pro is dead. No more development. What a shame to drop a great program that could be really top notch with just a bit more work. I have resigned myself to...
Mike, Well, I'm watching, but........ Sure wish Doug Y. would grace us with another update or sumthin'. The prog works ok, but I long for an MDI feature. RichD...
The list is essentially dead because there is nothing left to discuss. CNCPro is in it's finished state and has been for a few years (and what is wrong with...
Hi, guys, It would be nice hearing from the developer himself about the status of this project but since he shyes away from people that's his choice. I am...
When I bought cncpro, it had a couple of things tcnc didn't - seems to me it may have been backlash comp, constant velocity or something else.... Much easier...
... In my view CNCpro has a better operator interface. Its mostly done with one screen and seems eaiser to use. Of course, I have used CNCpro for 2 or 3 years,...
... Lookahead on cncpro is one block. That is really not as bad as it sounds. As long as you configure your post processor to account for this you will...
Doug wrote, ... For surfacing one-block lookahead seems useless. But I am not too knowledgeable about post-processors. When I have 500 little G1's that ...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
